==========================================================================
Command: rec (¸í·É¾î ÀÔ·Â ÈÄ Enter)
RECTANG
Specify first corner point or [Chamfer/Elevation/Fillet/Thickness/Width]: 1,1 (½ÃÀÛÁ¡ ÀÔ·Â ÈÄ Enter)
Specify other corner point or [Area/Dimensions/Rotation]: 8,..
==========================================================================
Command: c (¸í·É¾î ÀÔ·Â ÈÄ Enter)
CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: 5,5 (¿øÀÇ Áß½ÉÁ¡ ÀÔ·Â ÈÄ Enter)
Specify radius of circle or [Diameter] <2.0000>: 4 (¿øÀÇ ¹ÝÁö¸§..
==========================================================================
Command: cone (¸í·É¾î ÀÔ·Â ÈÄ Enter)
Current wire frame density: ISOLINES=4
Specify center point for base of cone or [Elliptical] <0,0,0>: 5,5 (Áß½ÉÁ¡ ÀÔ·Â ÈÄ Enter)
Specify radius for base of co..
==========================================================================
Command: cylinder (¸í·É¾î ÀÔ·Â ÈÄ Enter)
Current wire frame density: ISOLINES=4
Specify center point for base of cylinder or [Elliptical] <0,0,0>: 4,4 (¿øÅëÀÇ Áß½ÉÁ¡ ÀÔ·Â ÈÄ Enter)
Specify radius for..