- Áß½ÉÁ¡°ú ¹ÝÁö¸§À» ÀÌ¿ëÇÑ ¹æ¹ýÀ¸·Î ¿øÀ» ±×¸°´Ù.
==========================================================================
Command: c (¸í·É¾î ÀÔ·Â ÈÄ Enter)
CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: 0,0 (Áß½ÉÁ¡ ÀÔ·Â ÈÄ Enter)
Specify radius..
- 3Á¡À» Áö³ª°¡´Â È£¸¦ ±×¸°´Ù. (½ÃÀÛÁ¡, Áß°£Á¡, ³¡Á¡)
==========================================================================
Command: a (¸í·É¾î ÀÔ·Â ÈÄ Enter)
ARC Specify start point of arc or [Center]: -6,0 (½ÃÀÛÁ¡ ÀÔ·Â ÈÄ Enter)
Specify second point of arc or [C..
==========================================================================
Command: rec (¸í·É¾î ÀÔ·Â ÈÄ Enter)
RECTANG
Specify first corner point or [Chamfer/Elevation/Fillet/Thickness/Width]: -6,3 (½ÃÀÛÁ¡ ÀÔ·Â ÈÄ Enter)
Specify other corner point or [Area/Dimensions/Rot..
==========================================================================
Command: spl (¸í·É¾î ÀÔ·Â ÈÄ Enter)
SPLINE
Specify first point or [Object]: -8,-6 (½ÃÀÛÁ¡ ÀÔ·Â ÈÄ Enter)
Specify next point: -6,-4 (µÎ¹ø° Á¡ ÀÔ·Â ÈÄ Enter)
Specify next point or [Close/Fit toleranc..
==========================================================================
Command: l (¸í·É¾î ÀÔ·Â ÈÄ Enter)
LINE Specify first point: 2,2 (½ÃÀÛÁ¡ ÀÔ·Â ÈÄ Enter)
Specify next point or [Undo]: @6,0 (¼±ÀÇ ³¡Á¡ ÀÔ·Â)
Specify next point or [Undo]: (Enter)
Command: e..